Quick Installation and User Manual
Add Your Heading Text Here
Step 1：Find your cell tower direction by logging into the website http://www.cellmapper.net
Step 2：Install the outdoor antenna and point it in the direction of your cell tower
Step 3：Install indoor antennas, keep a distance from outdoor antenna.
Step 4：Cable the system and power on.
Outdoor antenna installation height
The antenna installation height must over your roof line, reach 60% to 80% of the height of tall objects within 100 feet. Such as houses or trees. Never exceed the height of the trees!
Antenna mutual position
For the outdoor antenna:
1.The front radiation main beam angle is about 90 degrees;
2.There is a very less energy radiation area behind the antenna, which
we call it “blind area”. The angle of the blind area is about 60 degrees;
For the indoor antenna: The radiation beam is omnidirectional, the
energy is evenly distributed in the direction of 360 degrees.
Do not face the outdoor antenna to the indoor antenna.
Ensure the distance, keep indoor antenna in the blind area( the best solution).
Ensure the distance, indoor antenna outside of blind area but it’s at rear side of the outdoor antenna( good solution).
Do not set the indoor antenna at the front side of the outdoor antenna.
Find your cell tower nearby!
Step 1: Visit website www.cellmapper.net. Find your location on the map and zoom in. Select Provider. You will find the cell tower around your house.
Step 2:Find your cell tower Click the red or green dot on the map that represents the base station, and the detailed information of the base station will be displayed The first important information, you can see from the picture, the coverage area (shaded part) of each base station is different. You have to find a base station with signal coverage to your house, or the coverage direction is facing you, and the coverage area is closest to you. The second important information, you can scroll the information content on the left to find the specific carrier information of this base station, including the communication standard and frequency band.
Must read
To uphold network protection standards and ensure compliance, all active cellular devices must maintain a separation distance of at least six feet between the inside unit antenna and outside unit antenna and at least four feet of separation distance from the inside unit. Use only the power supply provided in this package. Use of a non-Amazboost product or accessory may result in damage to the equipment or components of the equipment. The inside unit is designed for use in an indoor, temperature-controlled environment (less than 100 degrees Fahrenheit). It is not intended for use in attics or similar locations where temperatures may be in excess of that range.
RF Safety Warning: Any antenna used with this device must be located at least 8 inches from all persons.
This is a CONSUMER device
BEFORE USE ,you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent .Most wireless provider consent to the use of signal boosters .Some providers may not consent to the use of this device on their network .If you are unsure ,contact your provider.
In Canada,BEFORE USE You must meet all requirements set out in ISED CPC-2-1-05.You MUST operate this device with approved antenna and cables as specified by the manufacturer .Antennas MUST be installed at least 20cm (8inches) from(i.e., MUST NOT be installed within 20 cm of)any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider. WARNING.E911 location information may not be provided or may be inaccurate for calls served by using this device.This device may be operated ONLY in a fixed location for in-building use.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by Amazboost could void the authority to operate this equipment. FOR MORE INFORMATION ON REGISTERING YOUR SIGNAL BOOSTER WITH YOUR WIRELESS PROVIDER, PLEASE SEE BELOW:
Sprint:https://www.t-mobile.com/support/coverage/register-a-signal-booster
T-Mobile/MetroPCS:https://www.t-mobile.com/support/coverage/register-a-signal-booster
Verizon Wireless:https://www.verizon.com/solutions-and-services/accessories/register-signal-booster/
AT&T:https://securec45.securewebsession.com/attsignalbooster.com/
U.S. Cellular:https://www.uscellular.com/support/fcc-booster-registration